Description
AS3 Performance Factory Series rear sprockets offer the best of both worlds - the strength of steel and the lightness of aluminium. This creates an extremely durable rear sprocket. The outer ring, made from hardened steel with a nickel coating, lasts up to three times longer than an aluminium sprocket. The inner ring, crafted from aircraft - grade 7075 - T6 aluminium, is up to 50% lighter than a standard steel sprocket. With 52 teeth, it fits a wide range of Honda models from 1986 - 2023, including CR 125, CR 250, CR 500, CRF 250 R/X, CRF 450 R/X/RX, CRF 150 F, CRF 230 F, CRF 250 F, and XR 650. Its features include a long - lasting outer ring, a lightweight inner ring, resistance to bending compared to aluminium sprockets (perfect for enduro), an anodised finish with AS3 branding, manufacturing by a leading sprocket company, testing on tough sand tracks, a 12 - month warranty from a UK company, and you'll get the exact sprocket as shown in the picture.
Using this AS3 rear sprocket is easy. Just replace your old sprocket with this one following your motorcycle's standard sprocket replacement process. When installing, make sure it's properly aligned to avoid any issues. As for maintenance, regularly clean the sprocket to remove dirt and debris. You can use a mild soap and water solution. After cleaning, dry it thoroughly to prevent rust. Check the sprocket's teeth periodically for signs of wear. If you notice excessive wear, it's time to replace it. Also, avoid over - tightening the sprocket as it can cause damage. Remember, this sprocket comes with a 12 - month warranty, so if you face any problems, reach out to the UK - based company that made it.
