Upgrade your braking performance with Venhill's AS3 Performance brake lines. These lines are crafted from marine - grade stainless steel, which eliminates hose expansion and significantly enhances the feel and response of your entire braking system. All AS3 Venhill brake lines are factory - tested to 1500 psi and meet or exceed TUV and DOT standards. Unlike most brake lines, they feature stainless steel swivel unions, allowing you to adjust the banjo angle slightly for perfect alignment on the caliper and master cylinder every time. These brake lines fit a wide range of Husqvarna models from 2005 - 2011. They are braided from marine - grade stainless steel with DuPont PTFE heat - resistant hosing. Chrome banjos with stainless steel swivel unions ensure a perfect fit. They come with 4 copper washers, are DOT and TUV approved, and are backed by a 12 - month warranty from a UK company. All parts are in stock for immediate dispatch, and custom colors or orders are available upon request.
Using your Venhill AS3 rear brake line hose is straightforward. First, make sure your motorcycle is turned off and on a stable surface. Locate the old brake line and carefully remove it, following the correct procedures to avoid brake fluid spillage. Then, install the new Venhill AS3 brake line. Use the stainless steel swivel unions to adjust the banjo angle for a perfect fit on the caliper and master cylinder. After installation, bleed the brake system to remove any air bubbles. This will ensure the best performance of your brakes. When it comes to maintenance, regularly check the brake line for any signs of wear, such as cracks or leaks. Keep the line clean and free from dirt and debris. If you notice any issues, replace the line immediately. Also, remember to check the brake fluid level regularly and top it up if necessary. With proper use and maintenance, your Venhill AS3 rear brake line hose will serve you well for a long time.
