Upgrade your braking system's look and feel with AS3 Performance Venhill brake lines. Made from marine - grade stainless steel, these lines eliminate hose expansion, greatly enhancing the feel and response of your brakes. Factory - tested to 1500 psi, they meet or exceed TUV and DOT standards. What sets them apart is the 303 stainless steel swivel unions, which let you fine - tune the banjo angle for perfect alignment on the caliper and master cylinder every time. Not only a performance boost, but with a smooth wipe - clean PVC finish, AS3 branding, and matt black banjos and bolts, they're a great visual upgrade over most OEM rubber hoses. These brake lines fit 2002 - 2007 Honda CB 900 Hornet and are set up in a race configuration (2 separate lines from the master cylinder to each caliper). Key features include braided marine - grade stainless steel construction, DuPont PTFE heat - resistant hosing, rubber grommets to hold the lines in place, improved brake feel and responsiveness, matt black banjos and bolts as shown, stainless steel swivel unions for a perfect fit, DOT and TUV approval, bolts and copper washers included, all parts in stock for immediate dispatch, and custom colors/orders available upon request. The photos are stock, but the parts you get will match the listed models.
Using these AS3 Venhill brake lines is straightforward. First, make sure your motorcycle is turned off and on a stable surface. Install the lines from the master cylinder to each caliper as per the race setup described. The stainless steel swivel unions allow you to adjust the banjo angle for a perfect fit. Tighten the bolts and ensure the copper washers are in place. When using your motorcycle, you'll notice an immediate improvement in brake feel and responsiveness. As for maintenance, keep the lines clean by wiping them with a soft cloth using the wipe - clean PVC finish. Check the rubber grommets regularly to make sure they're holding the lines in place. If you see any signs of wear or damage, contact us for replacement parts. Remember, these lines are factory - tested to 1500 psi and meet DOT and TUV requirements, so you can trust their quality. If you have any special requests for custom colors or orders, just let us know.
